tag:blogger.com,1999:blog-2144616298870686818.post2602006422859908730..comments2023-10-25T16:49:40.736+01:00Comments on Argapa Ukuleles - one size louder: Last linings installedSven Nyström, Argapahttp://www.blogger.com/profile/15686126502997392719noreply@blogger.comBlogger2125tag:blogger.com,1999:blog-2144616298870686818.post-32115254643238818192009-02-19T20:13:00.000+01:002009-02-19T20:13:00.000+01:00Well it's easier than you might think, Luther Ran ...Well it's easier than you might think, Luther Ran Mob. <BR/><BR/>I make pencil marks on the edges, then grind it in the sanding dish. Then check where the marks are gone, plane there a little with a miniature plane (to avoid endless sanding), make new marks and sand again.<BR/><BR/>Once all marks disappear at once, or really are all gone, the back radius is sorted. Then the back braces are shaped - oh you'll see about that in a few days. They're the ones that hold the shape of the back.Sven Nyström, Argapahttps://www.blogger.com/profile/15686126502997392719noreply@blogger.comtag:blogger.com,1999:blog-2144616298870686818.post-8124751416346838452009-02-19T20:04:00.000+01:002009-02-19T20:04:00.000+01:00I'm impressed. You actually work on the sopranos b...I'm impressed. You actually work on the sopranos before going to the office in the morning!<BR/><BR/>Or in my usual backwards manner of writing:<BR/>Your working on the sopranos in the morning before going to the office is impressing.<BR/><BR/>I must admit that I didn't really get how the shaping of the back radius was (is) done. Oh I understand the sanding part (I think) But not how you controll the shape of the back. How you know that each part of the sides get just enough sanding.Anonymousnoreply@blogger.com