Learning Ukulele 50 Sites Top 50 Ukulele Sites Argapa Ukuleles - one size louder: Neck work

Friday, November 17, 2017

Neck work

Good news - the workbench works great. It’s a true joy working at it. Maybe it’ll make me build more and faster again, thus revitalising this here blog as well. 

This week I’ve snuck down to work on the tenor neck of Lars’ double necker. I can’t continue with the body for it without preparing the neck pockets to see where everything ends up. 

The truss rod is installed and the fretboard made. I had a bit of a hard time with the frets, not being used to radiused boards, but it turned out ok in the end. 



Glueing the fretboard on in the vise, with some clamps and wedges for good measure. 

The board was straight along its edges and the neck was still wider so I put tape around first to stop it from slipping too far out of alignment, but didn’t bother with brads like I do on ukes when the neck is already attached to the body. I’ll plane the neck to match the fretboard and deal with alignment when I do the neck pocket. 



At the nut end, I trimmed the fretboard end and blended it together with the headstock with a Japanese gouge. 

Then I spent some time levelling and crowning the frets, but didn’t reach for the camera (phone) since my hands got so dirty. 



This weekend I’ll resaw some wood in my larger workshop at the summer house. November or not, I’m going out. 

No comments: