Learning Ukulele 50 Sites Top 50 Ukulele Sites Argapa Ukuleles - one size louder: Neck joint

Sunday, April 17, 2011

Neck joint

Neck joint number one of five, number two is also done but not in the picture. I make these by sanding the neck's end and heel area, constantly checking angle and alignment. I put Titebond glue on 90% of the area, and a drop of superglue at the top part near the soundboard.

Then I press them in my hands until the superglue sets, drill a hole from the inside with my angled drill, and screw the joint tight to press the Titebond.

Got it? I should make a post with some relevant picture. I might do that on the next one, tomorrow or tuesday night.

Post a Comment